Laravel Eager Loading - load() Vs. with()

with() vs load()
Both accomplish the same end results—eager loading a related model onto the first. In fact, they both run exactly the same two queries. The key difference is that with() eager loads the related model up front, immediately after the initial query (all(), first(), or find(x), for example); when using load(), you run the initial query first, and then eager load the relation at some later point.

X“Eager” here means that we’re associating all the related models for a particular result set using just one query, as opposed to having to run n queries, where n is the number of items in the initial set.

You may also like: Build your own Laravel artisan commands for your project

Eager loading using with()
If we eager load using with(), for example:

$users = User::with('comments')->get();


if we have 5 users, the following two queries get run immediately:

select * from `users`
select * from `comments` where `comments`.`user_id` in (1, 2, 3, 4, 5)
…and we end up with a collection of models that have the comments attached to the user model, so we can do something like $users->comments->first()->body.

“Lazy” eager loading using load()
In this approach, we can separate the two queries, first by getting the initial result:

$users = User::all();
which runs:

select * from `users`
And later, if we decide(based on some condition) that we need the related comments for all these users, we can eager load them after the fact:

if($someCondition){
$users = $users->load('comments');
}
which runs the 2nd query:

select * from `comments` where `comments`.`user_id` in (1, 2, 3, 4, 5)
And we end up with the same result, just split into two steps. Again, we can call $users->comments->first()->body to get to the related model for any item.

Conclusion:
When to use load() or with()?

load() gives you the option of deciding later, based on some dynamic condition, whether or not you need to run the 2nd query.

If, however, there’s no question that you’ll need to access all the related items, use with().

Source : amitmerchant.com

Post a Comment

Post a Comment (0)

Previous Post Next Post